Nearing completion of the powerpod for the Duck. In the pictures below you will see the Logan Hole Cutter that I used to make a hole for the motor wires to pass through. The top view shows the 4˚ right thrust in the firewall. The battery is used for photo purposed to keep the pod from tipping forward. I used blind nuts or t-nuts to help mount the motor. What you don’t see is the bottom of the pod side panels cut at an 8˚ angle to fit for better gluing on the wing. I used a Hot Wire Foam Factory Table to cut the angle. Worked really well. Next time I’ll take some pics.