Foam Board Flyers

  • Home
  • About
  • Contact

Scout #1 Pilot Figure

Posted on October 11, 2019 by funkhouser Posted in Pilots / Wheel Pants, Models, FT Simple Scout, Tips

The Scout looked unfinished without a pilot figure. So I came up with a solution similar to one I used before with the FT Old Speedster. Check that post out HERE. There is a hole in the foam board that is the top of the fuselage in the cockpit. I used a couple of pieces of foam board to make a base, then cut a slot for the profile pilot head to fit in. You may or may not want to glue the pilot in permanently.

« Scout #1 Finished
Pilot Alternatives »

Leave a comment Cancel reply

Your email address will not be published. Required fields are marked *

Categories

  • Scratch Building
  • Models
    • Flite Test
    • FT Old Speedster
    • FT Simple Scout
  • Tips
    • Motors & Firewalls
    • Painting
    • Radio Gear
    • Pilots / Wheel Pants
    • Landing Gear
    • Hot Gluing
    • Foam Board
  • Tools
    • Drawing
    • Sandiing
    • Tape
    • Skewers
    • LG Wire
    • Making Holes & Circles
    • Glue Guns / Sticks
    • Electrical
  • Other

Subscribe to Blog via Email

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 12 other subscribers

Gutenberg Editor

For those of you who are familiar with WordPress, you may be interested to know that this site is now using the new WordPress editor Gutenberg.

iFeature Pro 5.5 Premium WordPress Theme

© Foamboardflyers.com